Description
Dieser Friesenhengst wurde als 3D Modell von der talentierter Künstlerin Carola Funder erschaffen. Bei uns kannst du sie als unbemaltes Resin Modellpferd aus dem 3D Drucker in den verschiedensten Größen kaufen.
Unsere ABS Harz - Drucke zeichnen sich durch eine glatte Oberfläche aus und es besteht für den Kunden nicht mehr allzu viel Nachbearbeitungsbedarf. Jedoch wirst du wohlmöglich in der Version "eigene Nacharbeitung nötig" immer noch Stellen zum nachschleifen finden. Bestellst du dein Pferd bemal fertig mit Grundierung, kannst du direkt mit dem bemalen loslegen. Es bedeutet leider nicht,dass dein Druck bemalt wird, er ist nur fertig zum bemalen.
Ab 1:12 werden große Drucke in hohl gedruckt, wir härten unsere Drucke jedoch von innen und außen aus! Sollte ein Produkt in 1:12 kleiner sein (zbs. Katze,Fohlen etc) drucken wir es aber selbstverständlich noch massiv.
We deliver all our prints without support structures, so you don't have unnecessary work and waste. Thanks to secure packaging of the models, damage rarely occurs.
We never ship our prints unprocessed (except for B-stock). This means they are pre-sanded by us to the extent that you won't have much work left to do. However, you will still have a little work before painting :).
Ready for Painting Service: If you choose the option "ready for painting including primer," you can start painting directly at home.
Our prints are not intended as toys. Small parts, among other things, could break off and be swallowed. We therefore recommend our products for ages 14 and up.
🚫 Not food-safe and not suitable for mouth contact
- No food contact: This product is not food-safe or certified for contact with food or beverages. Never use it as tableware, cutlery, or for food storage. The product must also not be put into the mouth.
🧸 Not suitable as a children's toy
- Not a toy: This product is a decorative or collector's item (e.g., miniatures, housings, models) and not a certified children's toy according to the Toy Safety Directive (2009/48/EC).
- Choking hazard: Resin parts can break or splinter under strong mechanical stress. Sharp-edged small parts may be created, posing a risk of injury and choking.
🧼 Handling and skin contact
- Fully cured: The product is thoroughly cleaned and post-cured under UV light before shipping. In its cured state, the material is harmless when touched normally.
- Skin irritation: Should the product unexpectedly feel sticky, wash your hands thoroughly with soap and water immediately. In this case, avoid further skin contact and contact us for a replacement model.
☀️ Storage, care, and material properties
- UV sensitivity: ABS resin can change color (yellow) and become brittle if exposed to direct, long-term sunlight (UV light). Ideally, store the product indoors away from continuous direct sunlight.
- Heat sensitivity: Do not expose the product to high temperatures (e.g., dishwasher, microwave, near direct heat sources, or in a car during summer). The material may deform or lose stability.
⚖️ Disclaimer
- Personal responsibility: Use of this product is at the buyer's own risk.
- Limitation of liability: The manufacturer/seller assumes no liability for damages, injuries, or consequential losses resulting from improper handling, misuse, or failure to follow these safety instructions.
