Resin Printing Process
This is what the resin 3D printing process looks like. Support structures are needed for printing. These will be removed by us afterward.
Your privacy settings
As described in our Privacy Policy, we collect personal information from your interactions with us and our website, including through cookies and similar technologies. We may also share this personal information with third parties, including advertising partners. We do this to show you ads on other websites more relevant to your interests and for other reasons described in our Privacy Policy.
Sharing personal information for targeted advertising based on your interactions across websites may be considered a "sale," "sharing," or "targeted advertising" under certain U.S. state privacy laws. Depending on where you live, you may have the right to opt out of these activities. If you wish to exercise this right, please follow the instructions below.
When you visit our website with the Global Privacy Control opt-out signal enabled, depending on where you are located, we treat this as a request to opt out of activities that could be considered "selling" or "sharing" personal information or other uses that could be considered targeted advertising for the device and browser you used to visit our website.
Resin prints
Description below the images
Drain holes of a hollow-core slab
Even before the printing process, large, hollow models (most scales we print solid) receive drainage holes. This ensures that uncured resin drains during the printing process. We seal these holes afterward. You will only be able to faintly discern them :).
Curing hole
Hollow prints also receive one (or sometimes two, depending on the model) large hole. The UV lamp for internal curing is inserted through this hole. Afterwards, we seal this hole so that it's almost impossible to tell where it was :)
The tail will also be clean
Even with this cavity, everything drains out through holes in the tail.
A gap remains!
So that the prints can always breathe from the inside, a single air hole remains. However, we hide this in a location that is not easily visible. In horse models, this is usually under the ganaches (cheeks of the horse).
Curing from the outside
We pay great attention to proper curing. Our prints are cured by two 150-watt lamps over an extended period. This corresponds to many times the wattage recommended as a minimum requirement for UV curing. This ensures that even hidden corners are cured :)
We thoroughly sand every model beforehand
You won't have to do much sanding yourself, as we thoroughly pre-process each model and also ensure that the surface is nice and smooth.
Curing from within
All hollow prints are cured by us from the inside using very strong UV light. The example image shows how the lamp shines through the entire model (hole in the camel's hump). For very intricate models, we also use small UV bulbs that are inserted into the model's angles. However, our prints are only hollow at larger scales (usually from 1:12 upwards).
Ready for the customer
This is how a print that goes to the customer looks (not yet ready for painting and not primed)
Ready for painting
This is what a product with our special service "ready for painting + priming" looks like.
2Our manufacturing processes
FDM Printing:
FDM prints are significantly more stable than resin prints and are made of plastic. The FDM printer creates objects by layering multiple small plastic lines that bond together, slowly forming the object. Unfortunately, for smaller scales like figurines, this printing technique is nowhere near as precise and clean as a resin printer. However, for larger objects (e.g., 1:6 model horses or large busts), it presents no problem. The disadvantage of this printing method definitely lies in post-processing (the small print lines remain visible after printing). To achieve a completely smooth surface, extensive sanding is required, and possibly the use of spray filler (which significantly reduces sanding time). Once this work is done, FDM prints can also be very smooth. However, you will always receive FDM prints from us already pre-processed, so you don't have to do all the sanding yourself :).
Here are some example images of an FDM print from us:
